Park Air Systems Limited B63300HS User Manual
T6T 300 Watt VHF Transmitter
Page 129
Maintenance
To Change the Drive Assembly Profile or Save a Profile
(1)
Using a PC to Radio Interconnection Lead, Park Air part number 17E12600001, connect the
drive assembly’s front panel Microphone/Diagnostics connector to the PC’s Com Port 1 or Com
Port 2 (note which Com Port is used).
drive assembly’s front panel Microphone/Diagnostics connector to the PC’s Com Port 1 or Com
Port 2 (note which Com Port is used).
(2)
Run up the VFP software and check that a blank VFP screen (see Fig 32) is displayed.
Fig 32 Blank VFP Screen
(3)
At the Menu Bar, click on Serial Port and select either Com 1 or Com 2. The selection must
correspond to the port used to connect to the radio.
correspond to the port used to connect to the radio.
(4)
Load the required information from the radio, or from a stored file. The required information can
be radio settings, frequency channels, BIT information, or all of these.
be radio settings, frequency channels, BIT information, or all of these.
To load a previously stored file, select File > Open > All
or,
or,
File > Open >Settings
or,
File > Open > Channel
or,
File > Open > BIT
To load information from the radio, select Radio > Retrieve > All
or,
or,
Radio > Retrieve > Settings
or,
Radio > Retrieve > Channel
or,
Radio > Retrieve > BIT
(5)
If required, amend any radio Settings or Channel information.