Digital Monitoring Products Inc PC0110 User Manual

Mount the 1100R on a flat surface such as a wall or single-gang box near a wall outlet for the Model 376 plug-in 

power supply.  The 1100R Wireless Repeater is typically mounted in a location that will be located between the 

1100 Series transmitters and the 1100 Series Receiver used in the installation.  Install the repeater away from large 

metal objects.  Mounting the repeater on or near metal surfaces impairs performance.  When selecting the proper 

mounting location of a repeater, refer to the LED Survey Operation section.
Remove the cover from the plastic housing by squeezing both sides toward each other.  Secure the repeater to the 

wall in the desired location using the supplied screws in the mounting hole locations as shown in Figure 1.  Snap the 

cover back on the unit.   

Five LEDs display repeater operation and activity.  Refer to the table below as required.

PWR

Steady Green to indicate there is power to the repeater. 

RX

Flashes Yellow to indicate data is being received.

TX

Flashes Green to indicate data is being sent.

BAD

Steady Red to indicate the repeater cannot establish communication with the receiver.

GOOD

Steady Green to indicate communication has been established with the receiver.

J4

1

J1

1

Mounting Hole

Locations

LEDs

Tamper 

Switch

Squeeze to

Remove Cover

Battery 

Start

DC Power 

Supply 

Barrel Jack

Squeeze to 

Remove Cover

Mounting Screw