Digital Monitoring Products Inc PC0110 User Manual

The 1100R battery is used to provide 24 hours of backup battery power when AC power is not available.  The 

following situations can reduce battery life expectancy:

•  If the battery leads are not properly plugged into the connector
•  DC power supply is not connected or not plugged in

Observe polarity when plugging the battery connector into the header.  Use only DMP Model 1100RBAT.   
Removing the Battery Assembly

1. Remove the repeater housing cover.  
2. Disconnect the battery lead connector from the repeater J4 battery header.
3. Remove the battery PCB from the four standoffs.  
4. Properly dispose the used battery.

  Caution: Risk of fire, explosion, and burns.  Do not disassemble, heat above 212°F (100°C), or incinerate.   

 

Properly dispose of used batteries.

1. Align the four battery PCB standoffs with the standoff mounting holes. See Figure 2.
2. Snap the battery assembly in place.
3. Observe polarity and connect the battery lead connector to the repeater J4 battery header.

��

�

��

�

Battery Assembly 

standoff mounting holes

��

�

��

�