Digital Monitoring Products Inc PC0114R6 User Manual

1

2

When selecting a location to mount the 1100XH, keep in mind 

that the receiver should be centrally located between the 

1100 Series transmitters used in the installation and no more 

than 1,000 feet (305 meters) away from the panel. Be sure to 

mount the receiver away from large metal objects because it 

may impair the receiver’s performance. Also, be sure to not use 

shielded wire between the panel and receiver. 

1.  Remove the cover from the plastic housing.
2.  Use the included #6 screws to secure the 1100XH to the 

wall. See Figure 2 for mounting hole locations.

The 1100XH interfaces with the panel uisng the on-board X-Bus 

connection. Connect the red, yellow, green, and black wires to 

the 

PANEL terminal on the 1100XH and connect the other to the 

XBUS terminal on the panel. See Figure 2.

Note: The receiver can’t operate if it’s connected to the 

keypad bus.

Refer to the panel programming guide as needed.

1.  Reset the panel.
2.  At a keypad, enter 

6653 (PROG) to access the 

PROGRAMMER menu. 

3.  In 

SYSTEM OPTIONS, program a HOUSE CODE between 

1 and 50. See House Code Explained for more information.

4.  In 

ZONE INFORMATION, enter a ZONE NAME and press 

CMD.

5.  Select the 

ZONE TYPE and press CMD. 

6.  At 

NEXT ZN?, select NO. 

7.  Select 

YES when WIRELESS? displays. 

8.  Enter the eight-digit 

SERIAL# and press CMD.

9.  Enter the 

SUPRVSN TIME and press CMD. 

10.  At the 

NEXT ZN? prompt, select YES to finish 

programming or select 

NO for additional programming 

options.

3

The 1100XH High Power Wireless 

Receiver provides up to 100 

wireless zones for XR150 Series 

panels and up to 500 wireless 

zones for XR550 Series panels.

The 1100XH provides  

two-way, supervised 

communication using 900 MHz 

frequency hopping-spread-

spectrum technology. 

The 1100XH High Power Wireless 

Receiver contains additional 

transmit and receiver amplifiers 

to enable greater distances for 

1100 Series operation at greater 

distances or harsh building 

environments. The additional gain 

introduced by this amplification 

may inhibit proper communication 

with 1100 Series transmitters 

located within 4 feet of the receiver. 

This distance may be 8 feet when 

using the 1121 PIR or 9000 Series 

Wireless Keypads.

The 1100XH can be mounted up to 

1,000 feet (305 meters) from the 

panel enclosure and is equipped 

with a case and wall tamper.

DMP XR150/XR550 Series Panels

• 

One 1100XH High Power 

Wireless Receiver

• 

4-Wire Harness

• 

Hardware Pack