Digital Monitoring Products Inc PC0114R6 ユーザーズマニュアル
1100XH HIGH POWER WIRELESS
RECEIVER
Installation Guide
1
WIRE THE 1100XH
2
MOUNT THE 1100XH
Select a Location
When selecting a location to mount the 1100XH, keep in mind
that the receiver should be centrally located between the
1100 Series transmitters used in the installation and no more
than 1,000 feet (305 meters) away from the panel. Be sure to
mount the receiver away from large metal objects because it
may impair the receiver’s performance. Also, be sure to not use
shielded wire between the panel and receiver.
Mount the 1100XH
1. Remove the cover from the plastic housing.
2. Use the included #6 screws to secure the 1100XH to the
2. Use the included #6 screws to secure the 1100XH to the
wall. See Figure 2 for mounting hole locations.
The 1100XH interfaces with the panel uisng the on-board X-Bus
connection. Connect the red, yellow, green, and black wires to
the
PANEL terminal on the 1100XH and connect the other to the
XBUS terminal on the panel. See Figure 2.
Note: The receiver can’t operate if it’s connected to the
keypad bus.
PROGRAM THE PANEL
RF RX
RF TX
RF TX
PANEL RX
PANEL TX
WALL
TAMPER
ENABLE
DISABLE
DISABLE
STATUS
PWR
Figure 1: 1100XH High
Power Wireless Receiver
Refer to the panel programming guide as needed.
1. Reset the panel.
2. At a keypad, enter
2. At a keypad, enter
6653 (PROG) to access the
PROGRAMMER menu.
3. In
SYSTEM OPTIONS, program a HOUSE CODE between
1 and 50. See House Code Explained for more information.
4. In
ZONE INFORMATION, enter a ZONE NAME and press
CMD.
5. Select the
ZONE TYPE and press CMD.
6. At
NEXT ZN?, select NO.
7. Select
YES when WIRELESS? displays.
8. Enter the eight-digit
SERIAL# and press CMD.
9. Enter the
SUPRVSN TIME and press CMD.
10. At the
NEXT ZN? prompt, select YES to finish
programming or select
NO for additional programming
options.
3
DESCRIPTION
The 1100XH High Power Wireless
Receiver provides up to 100
wireless zones for XR150 Series
panels and up to 500 wireless
zones for XR550 Series panels.
The 1100XH provides
two-way, supervised
communication using 900 MHz
frequency hopping-spread-
spectrum technology.
The 1100XH High Power Wireless
Receiver contains additional
transmit and receiver amplifiers
to enable greater distances for
1100 Series operation at greater
distances or harsh building
environments. The additional gain
introduced by this amplification
may inhibit proper communication
with 1100 Series transmitters
located within 4 feet of the receiver.
This distance may be 8 feet when
using the 1121 PIR or 9000 Series
Wireless Keypads.
The 1100XH can be mounted up to
1,000 feet (305 meters) from the
panel enclosure and is equipped
with a case and wall tamper.
Compatibility
DMP XR150/XR550 Series Panels
What is Included?
•
One 1100XH High Power
Wireless Receiver
•
4-Wire Harness
•
Hardware Pack