Digital Monitoring Products Inc PC0126P User Manual

The DMP 9060 and 9063 are fully functioning supervised wireless keypads.  They provide installation flexibility while also 

offering optional codeless arming and disarming capabilities.  Each keypad provides:

• 

Custom 16-character home or business name

•  Four 2-button Panic keys
•  32-character display
•  Backlit keyboard with easy-to-read lettering
•  Internal speaker. 
•  Wall tamper protection
•  Keyboard and logo backlighting turns Red in alarm 

conditions

The Model 9063 keypad also provides a built-in proximity card 

reader designed to read DMP/HID proximity credentials for 

codeless arming and disarming.

XTL Panels

The 9000 Series Keypad includes the following items:

•  One wireless keypad mounted in a Thinline two-part housing (base and cover)

•  One 3.7V lithium battery

•  One 12 VDC DC Plug-in Power Supply

•  Serial number label

For your convenience, an additional pre-printed serial number label is included.  Prior to installing the device, record the 

serial number or place the pre-printed serial number label on the panel programming sheet.  This number is required during 

programming.  As needed, use the zone name and number label to identify a specific transmitter.

The 9000 Series Wireless Keypads can be programmed into the XTL through panel programming or using the wireless 

keypad association mode.
Note:  When a receiver is installed, powered up, or the panel is reset, the supervision time for transmitters is reset.  If the 

receiver has been powered down for more than one hour, wireless transmitters may take up to an additional hour to send 

a supervision message unless tripped, tampered, or powered up.  This operation extends battery life for transmitters.  A 

missing message may display on the keypad until the transmitter sends a supervision message.

Refer to the XTL Programming Guide (LT-1107) as needed.  Program the keypad as a device in 

Device Setup during panel 

programming.  At the Serial Number: prompt, enter the eight-digit serial number.  Continue to program the device as 

directed in the panel programming guide.  

Pressing the XTL RESET button 3 times within 5 seconds enables the keypad association mode. For one minute the panel 

listens for wireless keypads.  Any keypads not already associated with another panel are assigned to the first open keypad 

address. Keypads are automatically assigned addresses based upon the order in which they are detected.  A maximum of 4 

keypads may be associated with a panel.

The 9000 Series keypad provides a built-in survey capability in the Installer menu to allow one person to confirm keypad 

communication with the panel.  Refer to Accessing Keypad Wireless Survey later in this document.

32-Character Display

Data Entry Digit keys 

COMMAND Key

Back Arrow Key

Select Keys

Backlit Logo 

and Proximity 

Antenna