Digital Monitoring Products Inc PC0128 User Manual

The XT Series panel software can be updated via the panel’s programming (PROG) header. To update the

panel with a new software version, complete the following steps at the protected premise:

1. Place a jumper across the Reset (J16) header and then remove the yellow and green wires from keypad

bus terminals 8 and 9.

2. Connect a DMP 399 Cable from the J8 Programming Header to the serial port of your PC operating

Remote Link and containing the XT RU file. Requires Remote Link 1.43 or higher.

3. Start Remote Link and create or open the XT Series control panel account that matches the panel to be updated.
4. Set the Connection Information Type to Direct with a baud rate of 38400 and choose the appropriate COM port.
5. Select Panel>Remote Update, then select the correct RU file for the XT panel model.
6. While placing a short across the LOAD (J18) header, remove the jumper from the Reset (J16) header.

Click <Update> in Remote Link.

7. After the software version is updated, remove the short from the LOAD header. Place the jumper across

Reset (J16) then remove the 399 cable.

8. Replace the yellow and green wires to terminals 8 and 9.
9. Remove Reset (J16) jumper to resume normal panel operation.

The J24 header is provided to connect a 263G Digital Cellular Communicator, 263C CDMA Cellular

Communicator, or 263H HSPA+ Cellular Communicator. The cellular antenna connection protrudes through

the top of the enclosure.

Outputs

J11

1 

2 

3 

4

J16

Reset

J20

1100 Series

Wireless Antenna 

connection

To J24 Celllular 

header

Connect 

antenna to 

right side 

only

Brass 

Washer

J18

Load

1100 Series

Antenna

(XT50)

J1

Ethernet

TX  RX

Wireless LEDs

Programming

J8

XMIT

RCV

65555

263 Module