Digital Monitoring Products Inc PC0128 User Manual

 

The XT50 Wireless Antenna terminal block J20 is located at the top right corner of the circuit board. The

antenna installs through a small opening in the top of the enclosure and is attached to the panel using the 

right terminal. The left terminal is not used.
The XT50 built-in wireless operates with DMP 1100 Series transmitters. See section 3.4 for a list of accessory

devices.

Green (TX): With a wireless house code enabled, the green LED flashes every time the receiver transmits

(32 times per second). If a house code is not programmed in the panel, the panel is reset, or the panel is

powered off, the green LED will be off. Under normal operation, the green LED flashes constantly with no

interruption or change.
Yellow (RX): The yellow LED flashes every time the receiver hears a message from a programmed wireless

transmitter. When a message is sent by a transmitter, typically by pressing or releasing the tamper switch,

the yellow LED should flash indicating that the receiver received a message from the transmitter. If the

LED never flashes, the transmitter is not getting through to the receiver. This could be because of a

misprogrammed serial number or the transmitter is too far away. Under normal operation, the yellow LED

will flash at every trip of every wireless transmitter and occasionally when the transmitters perform their

periodic check-in. It is not unusual for this LED to stay off for many minutes at a time when no transmitters

are communicating.

DMP keypads have removable covers that allow the base to be mounted on a wall, desk stand or other flat

surface using the screw holes provided on each corner.

Enable Wireless Keypad Association operation on both the keypad and panel.
To enable association operation in the keypad, access the Installer Options

Menu (3577 (INST)) and select RF Survey). The keypad logo LEDs turn on Red

until association is successful.
To enable association operation in the XT30/XT50 panel, reset panel 3 times

within 12 seconds. Allow the keypad bus Transmit/Receive LEDs to turn back

on between each reset.
For 60 seconds the panel listens for wireless keypads that are in the Installer Options Menu (3577 CMD) and

have not been programmed, or associated into another panel. Those keypads are assigned to the first open

device position automatically based upon the order in which they are detected. The keypad logo turns Green

to indicate it has been associated with the panel.

Programming

J8

XMIT

RCV