Digital Monitoring Products Inc PC0137R2 User Manual

 2 

738ZPLUS INSTALLATION GUIDE     |     DIGITAL MONITORING PRODUCTS 

4

After wiring the 738Zplus to the panel, use a DMP keypad to program Z-Wave Plus devices into 

the panel through the User Menu Z-Wave Setup option. This allows users to add devices through 

the User Menu or the Virtual Keypad App™ after installation. When possible, have the Z-Wave 

device near the 738Zplus during setup and programming.

Note: When programming Z-Wave devices into a XT50 or XTLplus panel, you can add 

multiple devices at once. If you add multiple devices at once, then you will name each 

device after they have all been added.

1.  Open the Keypad menu, press 

CMD until MENU? YES NO appears, and then press YES.

2.  After accessing the User Menu, press 

CMD until ZWAVE SETUP? appears. Press any select 

key/area.

3.  Select 

ADD. The screen displays PROCESSING.

4.  When prompted, press the button (or series of buttons if adding a thermostat) on the 

device you are adding. 

5.  The keypad displays that the device has connected to your system through the 738Zplus.

3

The 738Zplus has four wire connections to connect to the panel’s keypad bus. See Figure 4.

1.  Connecting the wires to the 738Zplus 

terminals.
a.  Connect the wire that delivers power 

to the module to the 

RED terminal.

b.  Connect the wire that sends data 

from the module to the 

YEL terminal.

c.  Connect the wire that receives data 

from the panel to the 

GRN terminal.

d.  Connect the ground wire to the 

BLK 

terminal.

2.  Carefully place the 738Zplus PCB back 

into the housing, and then snap the 

housing cover into place.

3.  At the panel, connect the wires to the 

keypad bus corresponding terminals.

Wiring to 

Keypad Bus

See Figure 4.

PTX Green LED - If the light is blinking, then data is being sent to the panel.

ZTX Green LED - If the light is blinking, then data is being sent to Z-Wave Plus devices.

ZRX Yellow LED - If the light is blinking, then data is being received from Z-Wave Plus devices. 

• 

The 738Zplus is a Z-Wave Security enabled device.

• 

The 738Zplus can be added to an existing network as a secondary controller by using the 

XFER (transfer) process and 

selecting secondary from the primary controller.

Note: See the Z-Wave setup section of your control panel user guide for more information. 

• 

The 738Zplus is compatible with Z-Wave Plus devices from all manufacturers.

• 

The 738Zplus can perform a factory default reset by initializing defaults in the panel programming menu.