Digital Monitoring Products Inc PC0181 User Manual

XTLplus Installation and Programming Guide

Digital Monitoring Products

INSTALLATION

Installation

4.1 Mounting Location Information

A location should be selected that is centrally located between the 1100 Series transmitters used in the

installation. Install the XTLplus away from metal objects. Mounting the panel on or near metal surfaces

impairs performance. When selecting the proper mounting location of a transmitter, refer to the LED Survey

Operation section of the specific installation guide for the transmitter being installed.

4.2 Mounting the Enclosure

The enclosure for the panel must be mounted using the provided #6 screws in the four mounting holes shown

in Figure 1. Mount the enclosure in a secure, dry place away from metal objects to protect the panel from

damage due to tampering or the elements. Mount the panel a minimum of 4 feet from any wireless

transmitters or repeaters. It is not necessary to remove the PCB when installing the enclosure.

Figure 1: Mounting Hole Locations

Primary Power Supply

5.1 DC Input

Mount the panel near a wall outlet for the Model 372-500-W plug-in DC power supply. In addition to powering

the panel, the DC plug-in power supply also charges the back-up battery. The 372-500-W must be located

within 100 feet of the panel using 22 AWG wire. Use the following steps to connect the plug-in power supply:

OBSERVE POLARITY

1. Using 22 AWG wire, connect the panel DC terminal (+) to the positive terminal on the power supply.
2. Connect the panel DC terminal (-) to the negative terminal on the power supply. See Figure 2.
3. Plug the power supply into a 120 Volt AC, 60Hz dedicated outlet not controlled by a switch.

Figure 2: DC Power Supply Connection

Mounting Hole Locations

ZWave

Module

WiFi

Antenna

RESET

LOAD

PROG

R B

+ DC -

LEV

LPC-0181

INSTALL GUIDE
LT-1434

CELL

MODULE

2015 DMP

WWW.DMP.COM

Wire Exits for DC

Power Supply

Model 372-500-W

DC Plug-in