Futaba Corporation T16SZ-24G User Manual
183
< Data >
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
©FUTABA CORPORATION 2017, 6 (1)
T14SG/FX-22 →T16SZ MODEL DATA CONVERSION
The model data (only latest version) of T14SG/FX-22 can be copied to T16SZ.
* SD card is required.
* The model data of T16SZ cannot be copied to T14SG/FX-22.
* The model data of T16SZ cannot be copied to T14SG/FX-22.
[Model data conversion method]
1. Attach a SD card that contains model data
1. Attach a SD card that contains model data
of T14SG or FX-22 to the SD slot of a T16SZ.
2. Turn on the power switch, and the Data
Converter should run.
3. The converter shows a list of model data in
the card. Select a model data that you want
to convert and push "CONVERT" → "Yes" key,
and the converter should begin converting
data.
4. If the convert succeeds, the converter will
show the following message. The converted
data are copied to the internal memory of
the T16SZ. Hence, if the T16SZ does not have
free spaces of its internal memory, converts
must fail.
* When SD card cannot be recognized, it may be able to
be used if it reformats by SD formatter offered from SD
Association.
SD formatter is downloadable from SD Association
https://www.sdcard.org/ (As of June, 2017)
https://www.sdcard.org/ (As of June, 2017)
CAUTION
After the completion of a data copy should fully
perform a check of operation on the model to
be used.
Check well all the directions of operation and
all the operation switches.
5. The converter can accept model data
made by T14SG or FX-22 with the latest
software only. If you try to convert model
data made by old version software, the
converter must fail to convert and show
the following error message. If this message
is shown, do the following procedure to
update the model data in order to avoid
this limitation.
(a) First, update a T14SG or FX-22 to the latest software.
(b) Load the model data failed to convert into the T14SG or
(b) Load the model data failed to convert into the T14SG or
FX-22 with the latest software, and the model data should
be updated to the latest format.
(c) Save the updated model data to a SD card.
(d) Retry to convert the updated model data on a T16SZ.
(d) Retry to convert the updated model data on a T16SZ.