UTC Fire & Security Americas Corporation Inc 569E-LMRISE User Manual
Learn Mode Rate of Rise Heat Sensors Installation Instructions
3
Figure 3. Mounting holes
Replacing the batteries
When the sensor battery gets low, the sensor transmits a low
battery signal. The panel receives this signal and sounds
trouble beeps through the system sirens. Pressing the Status
button identifies the sensor with the low battery.
Replace the battery immediately when this condition occurs,
using the following batteries: Eveready
©
9-Volt Alkaline
Energizer (No. 522); Duracell
©
9-Volt Alkaline (MN1604); or
UltraLife
©
9-Volt Lithium.
Battery disposal
Alkaline and lithium batteries that are not longer usable are
considered hazardous waste. Be sure to properly dispose of
the old batteries according to your local hazardous waste
disposal laws.
Specifications
Compatibility
Interlogix/GE Learn Mode panels and
receivers
receivers
Frequency
319.5 MHz
Power requirements
One 9-volt alkaline or lithium battery
Operating temperature 60-460-95/NX495, 60-460-95-LB:
40 to 100°F (4 to 37°C)
60-460-01-95/NX-496:
32 to 150°F (0 to 66°C)
32 to 150°F (0 to 66°C)
Storage temperature
60-460-95/NX-495, 60-460-95-LB:
-30 to 120°F (-34 to 48°C)
-30 to 120°F (-34 to 48°C)
60-460-01-95/NX-496:
-30 to 140°F (-34 to 60°C)
-30 to 140°F (-34 to 60°C)
Maximum humidity
90% relative humidity, noncondensing
Dimensions
4.4 in. (11.18 cm) diameter x 2.2 in. (5.59 cm)
depth
depth
Regulatory information
Manufacturer
UTC Fire & Security Americas Corporation, Inc.
1275 Red Fox Rd., Arden Hills, MN 55112-6943,
USA
1275 Red Fox Rd., Arden Hills, MN 55112-6943,
USA
UL listings
UL 985 Household Fire Warning System Units
UL 521 Heat Detectors for Fire Protective
Signaling Systems
Signaling Systems
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by UTC Fire and Security
could void the user’s authority to operate the equipment.
could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference,and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Operation is subject to the following two conditions: (1) this device may not
cause interference,and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence
standard RSS (s). Son fonctionnement est soumis aux deux conditions
suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet
appareil doit accepter toute interférence, y compris celles pouvant causer un
mauvais fonctionnement de l'appareil.
standard RSS (s). Son fonctionnement est soumis aux deux conditions
suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet
appareil doit accepter toute interférence, y compris celles pouvant causer un
mauvais fonctionnement de l'appareil.
In accordance with FCC requirements of human exposure to radiofrequency
fields, the radiating element shall be installed such that a minimum
separation distance of 20 cm is maintained from the general population.
fields, the radiating element shall be installed such that a minimum
separation distance of 20 cm is maintained from the general population.
FCC: B4Z-569E-LMRISE
IC: 1175C-569EROR
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Canada.
Contact information
For contact information, see www.utcfireandsecurity.com or
www.interlogix.com.
For technical support, toll-free: 888.437.3287 in the US
including Alaska, Hawaii, Puerto Rico, and Canada. Outside
the tool-free area, contact your dealer.
GE is a trademark of the General Electric Company and is
under license to UTC Fire & Security, 9 Farm Springs Road,
Farmington, CT 06034-4065
Copyright © 2011 Interlogix, a UTC Fire & Security Company.
All rights reserved.