UTC Fire & Security Americas Corporation Inc 785B-ALTP User Manual
1
,QVWDOODWLRQ,QVWUXFWLRQV
ZZZ*(,QWHUORJL[FRP
*(,QWHUORJL[
'
Product
Summary
Summary
The Dialog™ QS1000 Allegro Remote Station is a wireless wall-mount remote station designed
to provide remote security system control and status checking. The Remote Station allows the
user to perform the following functions:
to provide remote security system control and status checking. The Remote Station allows the
user to perform the following functions:
•
Arming and Disarming
•
Activating Police, Auxiliary and Fire Panic Alarms
•
Checking of System Status
The remote station has the following features:
•
One Hardwire Input
•
Built-in Siren
•
Wall Tamper
•
Custom Liquid Crystal Display (LCD)
•
Armed and Ready LEDs
Programming
The following steps describe the general process for programming (learning) the remote station
into panel memory. Refer to the specific panel Installation Instructions or Reference Manual for
complete programming details.
into panel memory. Refer to the specific panel Installation Instructions or Reference Manual for
complete programming details.
¾
To program the remote station into the system:
1. Enter the appropriate code to access the panel menus.
2. Enter the panel Learn/Add Sensors/Devices menu.
3. Change the sensor number if necessary.
4. Press and hold both Police Panic buttons on the remote station.
2. Enter the panel Learn/Add Sensors/Devices menu.
3. Change the sensor number if necessary.
4. Press and hold both Police Panic buttons on the remote station.
¾
To set the volume of status beeps from the remote station:
1. Press and hold the 8 button. The remote station will beep every 2 seconds.
2. Release the button when the desired volume is reached.
2. Release the button when the desired volume is reached.
Mounting
Use the following procedure to mount remote station to the wall or wall studs.
¾
To mount the remote station:
1. Remove the remote station from the back mounting plate by lifting
the tab located on the top and pulling back.
2. Remove the wiring knockout.
3. Feed all device wires through the knockout and place the back
mounting plate in position against the wall.
4. Level the back mounting plate and mark the top and bottom mounting holes.
You must be free of static electricity before handling circuit boards. Wear a grounding
strap or touch a bare metal surface to discharge static electricity.
strap or touch a bare metal surface to discharge static electricity.
Static
Tab
Antenna
(Standard)
Figure 1. Tab location
'RFXPHQW1XPEHU5HY$
6HSWHPEHU
35(/,0,1$5<
Preliminary 9/19/03
'LDORJ46
$OOHJUR5HPRWH6WDWLRQ
3DUW1R5