User ManualTable of ContentsPart No. 60-982-95R1Dialog QS10001Allegro Remote Station1Product Summary1Programming11. Enter the appropriate code to access the panel menus.12. Enter the panel Learn/Add Sensors/Devices menu.13. Change the sensor number if necessary.14. Press and hold both Police Panic buttons on the remote station.11. Press and hold the 8 button. The remote station will beep every 2 seconds.12. Release the button when the desired volume is reached.1Mounting1Figure 1. Tab location11. Remove the remote station from the back mounting plate by lifting the tab located on the top and pulling back.12. Remove the wiring knockout.13. Feed all device wires through the knockout and place the back mounting plate in position against the wall.14. Level the back mounting plate and mark the top and bottom mounting holes.15. Install anchors where studs are not present.26. Partially insert a screw into the top mounting hole location then hang the back mounting plate on the screw.27. Recheck for level, insert the lower screw, and tighten both mounting screws.28. Install the antenna. There are three antenna options to choose from:2Figure 2. Antenna configurations29. Place the remote station cabinet into the back mounting plate and snap into place.2Connecting Detection Devices to the remote station2Figure 3. Wiring N/C Intrusion Detection devices2Important ! The 2.2 kOhm EOL resistor must be installed across termi nal 3 and 4 even when no detection device is connected. If this is not done the panel will indicate the zone is open.2Connecting the AC Power Transformer3Figure 4. Connecting a Power Transformer3Connecting the Backup Battery Pack3Figure 5. Connecting the Battery Pack31. Remove the panel housing from the back mounting plate by lifting the tab located on the top of the remote station and pulling back.32. Slide the battery pack into the space provided on the back of the remote station (Figure 5).33. Plug the battery pack lead into the slot provided next to the wire terminals (Figure 5).34. Replace the remote station housing on the back mounting plate and snap into place.3Powering Up the Remote Station3Specifications4Notices4Document Number: 466-2091 Rev. A September 2003 PRELIMINARY1Preliminary 9/19/031Size: 195 KBPages: 4Language: EnglishOpen manual