UTC Fire & Security Americas Corporation Inc 799E5-SOUND User Manual

P/N 466-5401

• REV B • 9MAY18

3 / 6

2. Hold the tester speaker directly on top of the sensor and

activate the tester. The sensor will alarm; then it will go

into test mode for one minute. While in the test mode,

the LED on the sensor will blink continuously.

Extend the test mode time by activating the tester at

least once a minute.

3. Holding the tester near the surface of the glass and

behind any closed drapes or blinds, aim the tester at the

ShatterPro and hold down the test button (see Figure 5:

Testing the ShatterPro on page 2).

Remember, the ShatterPro should not be installed in

rooms with lined, insulating, or sound deadening drapes

or rooms with closed wooden window shutters inside.

4. Observe the LED on the sensor. If the sensor is

detecting the tester signal, the LED will remain on but

will stop blinking momentarily. This indicates the sensor

is mounted within range and is working properly.

If the sensor LED blinks continuously when the test

button is pressed, the sensor is not detecting the tester

signal. Replace the tester battery if you suspect it is not

producing a strong signal. If you are certain that the

tester signal is strong, reposition the sensor closer to

the window and retest. Add more sensors if necessary

to achieve complete coverage.

5. The sensor will automatically exit test mode if it does not

sense any signals for 1 minute.

The “Hand Clap” Test

You can test the ShatterPro without enabling the test mode

by clapping your hands loudly under the sensor. This sound

will not trip the alarm, but the sensor LED will blink twice.

This is a signal that the sensor has power and that the

microphone and circuit board are functioning.

Adding the ShatterPro to Panel Memory

The following procedure is a general guideline for adding

(learning) the sensor into panel memory. Refer to your panel

installation instructions or reference manual for complete

details.

1. Set the panel to Program mode.

2. Proceed to the LEARN SENSORS menu.

3. Select the appropriate sensor group and sensor

number.

4. Trip the tamper switch on the sensor.

5. Repeat the above steps until all sensors are added

(learned) into the panel.

6. Exit Program mode.

Testing the System

The following steps describe general guidelines for testing

the sensor. Refer to your panel installation instructions or

reference manual for complete details.

1. Set the panel to the Dealer Sensor Test mode.

2. Use the hand-held tester to trip the sensor.

3. Listen for status beeps (or a voice message) to indicate

that the panel is receiving transmissions from the sensor

Look for a message on the touchpad display.

Note: Refer to your panel installation instructions for

troubleshooting information.