UTC Fire & Security Americas Corporation Inc 801-IXT User Manual
Chapter 4
Programming
31
System programming
To enter system programming mode, do the following:
1. Enter the system menu.
2. Scroll up/down to System programming, then press Enter.
3. The panel displays Enter code.
4. Enter your master code, then press Enter.
At this point, you are in the System programming submenu. At this level, the following items are accessible:
•
Access codes
•
Security
•
Phone #s
•
Timers
•
Siren options
•
Light control
•
System tests
The sections below describe the options that you can program in the System programming menu.
Access codes
There are three types of access codes: master, user, and duress.
Master code. The master code is your most powerful code and can be used for all user operations
including programming. To change the master code, do the following:
including programming. To change the master code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to Master code, then press Enter.
4. The current value of the code now flashes.
5. Enter a new code (use correct length), then press Enter.
6. Press Status repeatedly to exit.
The initial value of the master code is 123, 1234, 12345, or 123456, depending on the installer-
programmed access code length.
programmed access code length.
User codes 1 to 8. There are eight user codes, which can be used for many user operations, but not
subdisarming, programming, or bypassing sensors.
subdisarming, programming, or bypassing sensors.
To change a user code, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to the user code you want to change, then press Enter.
4. The current value of the code now flashes.