UTC Fire & Security Americas Corporation Inc TX-1010-01 User Manual

DesignLine Slim Door/Window Sensor

Installation Instructions

When the system indicates the sensor battery is low, replace it 
immediately. Use the recommended replacement batteries (see 

) or contact technical support for more information.

To replace the batteries, do the following:
1.

To remove the sensor cover, press a small flathead screw-
driver into the slot on both sides of the sensor and turn the 
screwdriver 90 degrees. This will disengage the clips 
holding the cover and base (Figure 1 on page 1).

2.

Place a small flathead screwdriver in the slot between the 
metal clip and the battery and twist the screwdriver slightly 
while holding back one of the black plastic edges holding the 
battery. Dispose of the old battery as required by local laws.

3.

Insert the replacement battery with the + sign facing out.

4.

Verify programming and RF communication with the panel. 
See 

The sensor ships with a six-inch external contact lead. To use the 
external contact, open the transmitter, plug in the external contact 
header (J1), and connect the brown and blue leads to the external 
contact.

The external wire cannot be longer than 3.3 ft. (1 m).

This device complies with part 15 of the FCC rules. Operation is subject to the 

following conditions: 
1. This device may not cause harmful interference. 
2. This device must accept any interference received, including interference 

that may cause undesired operation. 

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment. 
FCC ID: B4Z-TX-1010-01
Industry Canada ID: 1175C-TX101001

 

Battery

Panasonic 2032, 3 VDC, 225 mAh, lithium 

coin battery (5-year typical battery life)

Transmitter frequency

319.508 MHz (crystal controlled)

Transmitter frequency tolerance ± 8 kHz
Transmitter bandwidth

24 kHz

Modulation type

Amplitude shift key (ASK)

Unique ID codes

16 million

Peak field strength

Typical 30,000 uV/m at 3m

External input sampling current 20 uA
Reed switch magnetic sensitivity 10 to 20 amp turns
Reed sensitivity

0.38-in. (0.97-cm) gap

Magnet type

Nd-Fe-B, N45

Magnet dimensions (WxHxD)

1.3 x 0.435 x 0.312 in. (3.3 x 1.1x 0.79 cm)

Supervisory interval

64 minutes

Operating temperature

10 to 120°F (-12 to 49°C)

Enclosure

PC-540

Weight

0.55 oz. (15 g)

Dimensions  (WxHxD)

1.00 x 2.45 x 0.35 in. (2.54 x 6.22 x 0.89 cm)

Colors

White or brown

Toll-free: 888.GESECURity (888.437.3287 in the US, including Alaska and Hawaii; Puerto Rico; Canada). 

Outside the toll-free area: Contact your local dealer.