Andrew Wireless Innovations Group RPT-MR703P User Manual
U
SER
´
S MANUAL FOR BAND SELECTIVE REPEATERS
MR
X
03P
User'sManual.doc
Id.-No.:154999
Page 19
22-Jan-01
3.1.2. PSTN Modem
A Hayes compatible PSTN modem can be connected to the control module SM2009.
The telephone cable has to be fed through a labeled grommet of the connector panel
and must be connected to the designated clamps.
For the standard modem type DigiTel 56Euro, use clamps 2 and 3 to connect the
telephone lines a and b. Previous standard modems type DigiTel 34P use clamps 1
and 4. In case of failure try both possibilities to check the functionality of the modem
connection.
A Hayes compatible PSTN modem can be connected to the control module SM2009.
The telephone cable has to be fed through a labeled grommet of the connector panel
and must be connected to the designated clamps.
For the standard modem type DigiTel 56Euro, use clamps 2 and 3 to connect the
telephone lines a and b. Previous standard modems type DigiTel 34P use clamps 1
and 4. In case of failure try both possibilities to check the functionality of the modem
connection.
figure 3-1 Location of the PSTN Modem
∗ Note:
If a PSTN modem is required, the DIP-switches of the Ext. Alarms-
switch [4] on the control module has to be set to position OFF
“PSTN Modem”. The DIP-switch 2 of the Mode-switch [1] has to be
set to position ON “Remote Mode”.
switch [4] on the control module has to be set to position OFF
“PSTN Modem”. The DIP-switch 2 of the Mode-switch [1] has to be
set to position ON “Remote Mode”.