Furuno USA Inc 9ZWRTR115 User Manual

2.  WIRING

Turn on the multi function display device, and do the initial setup for the antenna unit.

1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate antenna unit.

Note: If an antenna unit is connected but does not appear in the [Radar Source] 
list, close the list and open it again. The name of the antenna unit should appear 
with a check mark, as in the example below.

4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap 

[Radar Initial Setup].

5. Referring to the tables below, set up the radar.

[Antenna Rotation]

Select the speed of antenna rotation.

[Antenna Heading Align]

See "How to align the antenna heading" on page 10.

[Main Bang Suppression]

If main bang appears at the screen center, slide the circle 
icon so that the main bang disappears, while watching the 
radar echo at the left-hand side of the display.

[Enable Sector Blanking]

Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start 
and end angles (0

°

 to 359

°

).

[Enable Sector 2 Blanking]

[Longitudinal (from bow)]

Referring to the figure on the right, enter the 
radar antenna positioning bow-stern (Longi-
tudinal) and port-starboard (Lateral) position 
from the origin.

[Lateral (-Port)]

[Antenna Height]

Select the height of the antenna above the waterline.

[Radar Monitoring]

Display various information regarding the connected ra-
dar.

[ARPA Advanced Settings]

Do not change these settings.

[Set Hardware To Factory 
Default]

Resets the radar selected at [Radar Source] to factory 
default.

[Reset Default Settings]

Resets [Radar] menu settings to default.

xxxxxxxx-xxxxxxxxxx

Origin

Origin