ICOM AP-3 User Manual

AP-3 SETTINGS

6

41

Ç

1. After completing the setting terminal settings (

☞

p. 38),

insert the wireless LAN card into the PCMCIA slot of
the AP-3 unit.

2. Connect the provided AC adapter to the DC jack of the

AP-3 and plug it into an AC outlet (

☞

section 4-3, p.

16). The AP-3 will power on.
• At first all lamps on the front panel will illuminate, then

only the [POWER] lamp will remain on.

3. Start up the computer (setting terminal). Do not start

any other computers in the network.
* If the connection is established normally, the

lamp (

☞

p. 6) on the front panel of the

AP-3 will illuminate.

* The green lamp of the wireless LAN card inserted

into card slot of the computer (setting terminal) will
flash continuously. The red lamp will flash when the
computer accesses the AP-3 unit.

* If the 

lamp on the front panel does not

illuminate, check the [Network Mode] and [ESS ID]
settings of the computer or restart computer. (

☞

pp.

38, 39 and 40)

* If the lamps of the wireless LAN card inserted into the

card slot of the computer do not illuminate or do not
behave as described above, check if the driver is
installed properly.

[IMPORTANT]
When the computer is connected to the AP-3 through a hub, do not
start up any computer other than the computer (setting terminal)
being used to adjust the settings  until the settings are completed.