ICOM AP-3 User Manual

AP-3 SETTINGS

6

43

r

Click this button to cancel any changes and return the
setting data to its original state (i.e., state before changes
were made). If the <Save> button has been pressed, the
settings will not return to their original state.

t

Click this button to save the setting changes and restart
the AP-3 unit.
* After the settings have been saved, a message sug-

gesting restarting the unit will be displayed next to this
button if restarting is required. Be sure to click this but-
ton when this occurs.

y

This area shows the version of the firmware (

☞

p. 66).

This manual assumes Version 1.0 is being used.

Set up the connection arrangement shown below and
check if a wireless connection with the AP-3 can be
made.
* The settings of the AP-3 unit are assumed to be original

factory settings.

PC

Ethernet cable

Wireless LAN card

Wireless LAN card

Wired terminal

AP-3

1. Insert the wireless LAN card into the AP-3 unit. (

☞

p.

10)

2. Connect the provided AC adapter to the AP-3 unit.

• At first all lamps on the front panel will illuminate, then

only the [POWER] lamp will remain on.

3. Start up the wired terminal (connected with an Ethernet

cable).

• The [LAN] lamp (

☞

p. 6) on the front panel of the AP-

3 will illuminate.

4. Make sure you can access the setting screen of the

AP-3 from the wired terminal. (

☞

p. 42)

5. Create a test folder and set the shared folder permis-

sion so that the folder can be shared.

·············································Continued on following page