Fibar Group S.A. FGS223 User Manual

10

OPERATInG THE DEVICE

Resetting the Switch 2: 
1.  Switch off the mains voltage (disable the fuse).
2.  Remove the Switch 2 from the wall switch box.
3.  Switch on the mains voltage.
4.  Press and hold the B-button to enter the menu.
5.  Wait for the visual lED indicator to glow yellow.
6.  Quickly release and click the B-button again.
7.  After few seconds the device will be restarted, which is signalled 

with the red lED indicator colour.

Resetting the device is 

not the recommend-

ed way of removing 

the device from the 

Z-Wave network. use 

reset procedure only 

if the primary con-

troller is missing or 

inoperable. Certain 

device removal can be 

achieved by the pro-

cedure of removing 

described in “Adding/

Menu allows to perform Z-Wave network actions. In order to use the 

menu:
1.  Switch off the mains voltage (disable the fuse).
2.  Remove the Switch 2 from the wall switch box.
3.  Switch on the mains voltage.
4.  Press and hold the B-button to enter the menu.
5.  Wait for the lED to indicate the desired menu position with colour:

•   GREEN - reset energy consumption memory
•  VIOLET - start range test
•  YELLOW - reset the device

6.  Quickly release and click the B-button again.

Controlling the Switch 2 using the B-button: 
The Switch 2 is equipped with a B-button, which allows to use the 

menu and perform the following actions:
1x click:
•  Cancel alarm mode (flashing alarm).
•  Select desired menu position (if menu is active).
•  Exit range test.
•  Turn 1st channel On/OFF.
3x click:
•  Send the node Info Z-Wave command frame (adding/removing).
Hold:
•  Enter the menu (confirmed by the lED indicator).