Fibar Group S.A. FGS223 User Manual

8

ADDInG/REMOVInG THE DEVICE

Adding (Inclusion) - Z-Wave device learning mode, allowing to add 

the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1.  Place the Switch 2 within the direct range of your Z-Wave controller.
2.  Identify the S1 switch.
3.  Set the main controller in (security/non-security) add mode (see 

the controller’s manual).

4.  Quickly, three times press the S1 switch.
5.  Wait for the adding process to end.
6.  Successful adding will be confirmed by the Z-Wave controller’s 

message.

In case of problems 

with adding/remov-

ing using S1 switch, 

use B-button instead 

(located on the hous-

ing)

While adding the 

Switch 2 to the net-

work with connected 

toggle switch, ensure 

that switch contact is 

open (off). Otherwise 

it will prevent adding/

removing the device 

to/from the network.

Removing (Exclusion) - Z-Wave device learning mode, allowing to 

remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1.  Place the Switch 2 within the direct range of your Z-Wave controller.
2.  Identify the S1 switch.
3.  Set the main controller in remove mode (see the controller’s 

manual).

4.  Quickly, three times press the S1 switch.
5.  Wait for the removing process to end.
6.  Successful removing will be confirmed by the Z-Wave controller’s 

message.

Removing the Switch 2 

from the Z-Wave net-

work restores all the 

default parameters of 

the device, but does 

not reset power me-

tering data.

Adding in security 

mode must be per-

formed up to 2 meters 

from the controller.