CBF Networks Inc. dba Fastback Networks 105 User Manual
IBR Installation Guide
Page 11 of 38
Doc # 770-00023.1
Jan. 23, 2015
The following settings are recommended when communicating with IBR via the serial interface:
115,200 bps
8 data bits
1 stop bit
No parity
No flow control
25 lines and 80 columns window size
NOTE: If a serial device is disconnected and then reconnected, CLI might be left in a “bad command” state and not respond to
legitimate commands. This condition can be cleared by entering the following sequence: <cr> <cr> <Ctrl-C>.
legitimate commands. This condition can be cleared by entering the following sequence: <cr> <cr> <Ctrl-C>.
3.2 Graphical User Interface (“GUI” or “Web UI”)
IBR’s internal HTTP browser-based GUI provides an easy alternate way to monitor and control IBR. A
detailed discussion of the GUI can be found in the CLI Guide.
detailed discussion of the GUI can be found in the CLI Guide.
3.3 Command Line Interface (“CLI”)
When an operator logs onto IBR, CLI will be launched in User Mode (i.e., startup mode), which provides
minimal functionality.
minimal functionality.
CLI is supported on the serial interface and via Telnet or SSH connections through the Ethernet
interface.
interface.
CLI uses a mix of IOS syntax.
Access to the full functionality mode (i.e., “Privileged” mode) can be controlled by password.
The commands shown below are the only commands available in User mode.
User Mode Commands
Command
Description
IBR102 >
!
Comments
enable
Enter Privileged Mode
exit
Exit from CLI
ping
Send messages to network hosts
telnet
IP address or host name of a remote system
traceroute
Determine route & transit time to a remote host
ip
IPv4
ipv6
IPv6
Detailed information can be found in the CLI Guide.
3.4 Access Control – Factory-Set User Names & Passwords
IBR can be configured to require a valid user ID and password for access. Two levels of access can be
established: minimum functionality and full functionality. Detailed instructions for controlling access to IBR
are contained in the CLI Guide.
are contained in the CLI Guide.
When CLI is launched and the “user name” dialog box appears, the user must enter a valid user name and
password. Factory-set user names are fbn and admin (either can be used) and the factory-set password
password. Factory-set user names are fbn and admin (either can be used) and the factory-set password