Zhongshan Grand Enterprise Co. Ltd FCGRAND User Manual
2
Wall Outlet Receivers:
NOTE: Wall Outlet Receivers feature 3-prong grounding plugs and are intended for use ONLY in 3-prong INDOOR
household AC outlets. DO NOT remove the round grounding prong. If your household AC outlets do not accept 3-prong
plugs then consult a qualified electrician to have your household AC outlets upgraded.
Red LED Indicators on wall Receiver Units indicate POWER SWITCHED ON at Wall Receiver Unit. Manual POWER ON/OFF
Override button on wall Receiver Units allows user to manually turn Wall Receiver Units ON or OFF in the event the Hand-Held
Remote cannot be located or if the battery in the Hand-Held Remote fails.
NOTE: Wall Outlet Receivers feature 3-prong grounding plugs and are intended for use ONLY in 3-prong INDOOR
household AC outlets. DO NOT remove the round grounding prong. If your household AC outlets do not accept 3-prong
plugs then consult a qualified electrician to have your household AC outlets upgraded.
Red LED Indicators on wall Receiver Units indicate POWER SWITCHED ON at Wall Receiver Unit. Manual POWER ON/OFF
Override button on wall Receiver Units allows user to manually turn Wall Receiver Units ON or OFF in the event the Hand-Held
Remote cannot be located or if the battery in the Hand-Held Remote fails.
Operation:
Remove Protective Tape From Battery Chamber.
Remove battery cover on Hand-Held Remote Control unit and remove protective tape. To do this: 1) Remove the battery
compartment safety screw with a # 3 Phillips screwdriver. 2) Slide the battery compartment cover off. 3) Remove protective tape.
4) Replace battery compartment cover by sliding into place. 5) Reinstall the safety screw.
Remove battery cover on Hand-Held Remote Control unit and remove protective tape. To do this: 1) Remove the battery
compartment safety screw with a # 3 Phillips screwdriver. 2) Slide the battery compartment cover off. 3) Remove protective tape.
4) Replace battery compartment cover by sliding into place. 5) Reinstall the safety screw.
1. Remove Safety Screw with # 3 Phillips Screw Driver.
2. Slide Battery Cover Out and Off.
3. Remove Protective Tape.
3. Remove Protective Tape.
4. Reinstall Battery Cover by sliding back into place
5. Reinstall Safety Screw. Do not over tighten.
5. Reinstall Safety Screw. Do not over tighten.
Red LED Indicator
Indicates Power ON
Manual ON/OFF
Press to turn Power
Press to turn Power
ON, Press to turn
Power OFF
Power OFF
Grounding Prong -
DO NOT REMOVE