CEI Conrad Electronic International Limited RCE-NOVAX350 User Manual
Canopy | 23
23.10 T.P.C.S
> T.P.C.S will be implemented in future firmware versions.
> T.P.C.S or Task Point Command System differs from commonly known way-points,
enabling the pilot to programm a full set of tasks (e.g. a full 360° rotation) to be
completed at each defined task point. [ Fig. 3 ] illustrates this.
completed at each defined task point. [ Fig. 3 ] illustrates this.
> T.P.C.S is activated in and controlled through the EYECONTROL app.
TP-1
TP-2
TP-3
TP-4
TP-5
TP-6
Fig. 3
24. CANOPY
24.1 Removing
• After removing the canopy, the PCB boards are exposed.
Do not touch any electronic components. Electrostatic
discharge causes damage.
discharge causes damage.
• Never remove the metal shield!
• Never use metal screws in the canopy!
• Never use metal screws in the canopy!
Unlock the two locks on either side of the canopy and carefully pull it off with one hand.
Caution! There is one cable connecting the canopy and the main board.
Caution! There is one cable connecting the canopy and the main board.
24.2 Mounting
GPS and compass are direction-dependent. Therefore, when mounting the canopy the
front LED must point to the »NovaX 350’s front.
Pay special attention to the wires and connectors; do not pinch wires! Do not apply any
force when replacing the canopy!
front LED must point to the »NovaX 350’s front.
Pay special attention to the wires and connectors; do not pinch wires! Do not apply any
force when replacing the canopy!