Springs Window Fashions LLC. SRF01 User Manual
8/25/2013
Springs Window Fashions, LLC
7549 Graber Road
Middleton, WI 53562-1096
Fax (608) 831-2184
Phone (608) 836-1011
7549 Graber Road
Middleton, WI 53562-1096
Fax (608) 831-2184
Phone (608) 836-1011
MODULAR DEVICES
– REQUIRED USER MANUAL STATEMENTS
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The SRF-01 Module has been certified for integration into products only by OEM
integrators under the following condition:
integrators under the following condition:
-The transmitter module must not be co-located or operating in
conjunction with any other antenna or transmitter.
conjunction with any other antenna or transmitter.
As long as this condition above is met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end-
required. However, the OEM integrator is still responsible for testing their end-
product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements,
etc.).
etc.).
IMPORTANT NOTE: In the event that this condition cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and
Industry Canada authorizations are no longer considered valid and the FCC ID
Industry Canada authorizations are no longer considered valid and the FCC ID
and IC Certification Number cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC and Industry
product (including the transmitter) and obtaining a separate FCC and Industry
Canada authorization.
End Product Labeling
The SRF-01 Module is labeled with its own FCC ID and IC Certification Number. If the
FCC ID and IC Certification Number are not visible when the module is installed inside
FCC ID and IC Certification Number are not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must
also display a label referring to the enclosed module. In that case, the final end
product must be labeled in a visible area with the following:
product must be labeled in a visible area with the following:
“Contains Transmitter Module FCC ID: 2AAVX – SRF01”
“Contains Transmitter Module IC: 11392A-SRF01”
or
“Contains FCC ID: 2AAVX – SRF01”
“Contains IC: 11392A-SRF01”