TSB Real Time Location Systems S.L. BCNEW0203 User Manual
MYSPHERA
• Ronda Auguste y Louis Lumiere 23, Nave 13 • 46980
Parque Tecnológico de Valencia • Paterna, Valencia • Spain
Telf.: +34 96 182 71 77
Telf.: +34 96 182 71 77
Pág. 4
How the communication network must be configured in order for the beacons to be able to
communicate with the location server is also described in this document.
communicate with the location server is also described in this document.
5. Wiring Installation
5.1. Plans with the position of the net sockets
The installation team is provided with the building plans in which the positions of the net
sockets are marked. Figure 1 shows a piece of a plan. The red round symbols mark the
position in which each beacon must be placed. The blue square symbols depict additional
net sockets that are not intended for beacons, but for PCs or TVs
sockets are marked. Figure 1 shows a piece of a plan. The red round symbols mark the
position in which each beacon must be placed. The blue square symbols depict additional
net sockets that are not intended for beacons, but for PCs or TVs
Figure 1
– Example of a plan; in red the beacons, in blue socket for TV or PC
The plan can be divided in several files, each of them with a section of the area to install.
Each of the fragments of the plan must be printed, as they are intended to be used to
note down by hand the following data:
Each of the fragments of the plan must be printed, as they are intended to be used to
note down by hand the following data:
-
Name of the net socket (it normally corresponds with the patch panel port).
-
Serial number of the beacon placed in that position (figure 1).
5.2. Wiring category
In case it is necessary to install new wiring, the cables to use must be at least UTP Cat 6
free of halogens. The lengths and placement of the cables must follow the regulation of
the structured cabling standards.
free of halogens. The lengths and placement of the cables must follow the regulation of
the structured cabling standards.
In case there is a previous cabling installation, the beacon is able to operate with cables of
Cat 3 or higher.
Cat 3 or higher.
5.3. Wiring installation
A net socket will be installed in each of the positions shown in the plan. Once installed, the
net socket identifier must be noted down on the printed plan. The identifier of the net
socket will follow the format used in the client’s network.
net socket identifier must be noted down on the printed plan. The identifier of the net
socket will follow the format used in the client’s network.