Duravit AG 596000098001 User Manual
9
> In case of contact with the acid, flush the affected areas with large amounts of clean water and consult a
doctor immediately.
• Keep batteries out of the reach of small children. Batteries can be life-threatening if swallowed. If a
battery has been swallowed, call for medical assistance immediately.
• Batteries may not be recharged, reactivated by other means, dismantled, exposed to fire or
short-circuited.
doctor immediately.
• Keep batteries out of the reach of small children. Batteries can be life-threatening if swallowed. If a
battery has been swallowed, call for medical assistance immediately.
• Batteries may not be recharged, reactivated by other means, dismantled, exposed to fire or
short-circuited.
• Always remove empty batteries from the remote control immediately. They may leak and cause
damage.
• Do not insert new and old batteries together in the remote control.
• Clean the battery and contacts before inserting the battery. Note the proper polarity.
• Remove the batteries if you do not use the remote control for an extended period.
• Do not expose the batteries to extreme conditions: avoid contact with hot surfaces or direct sunlight.
Otherwise there is a risk of leakage.
damage.
• Do not insert new and old batteries together in the remote control.
• Clean the battery and contacts before inserting the battery. Note the proper polarity.
• Remove the batteries if you do not use the remote control for an extended period.
• Do not expose the batteries to extreme conditions: avoid contact with hot surfaces or direct sunlight.
Otherwise there is a risk of leakage.
Compliance
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.