Duravit AG 596000098001 User Manual
26
Note!
Turn off
Turn off
“Auto flush” in case of water supply failure
>
If the water supply fails, please set the “Auto flush” function to “OFF”, see chapter 4.3.
8.7
Change new remote control
If the remote control is lost or faulty, a new remote control needs to be changed and matched.
Do not to activate the seat sensor while doing the match.
>
Check the unit mode. The SensoWash should be turned on. The status display
should be
green or orange illuminated.
>
Press the „Power“ button
on the seat unit to switch the SensoWash® off and the status
display
should be red illuminated.
>
Press the „Ladywash“ button
and „Rearwash” button
on the seat unit i
n order.
You will hear a “beep” tone to indicate entering the “Remote Control matching mode”.
>
Press any button on the new Remote Control.
You should hear three “beep” tones, which indicates the Remote Control matching is successful.
The above operations should be finished within 10 seconds.
8.8 Water filter
Clean the water filter regularly or when the water flow becomes smaller than usual.
> Dismantle right side panel.
> Clean the water filter according to the instructions next to it.
> Install right side panel.
> Dismantle right side panel.
> Clean the water filter according to the instructions next to it.
> Install right side panel.
Dismantle and assemble the side panel please see chapter 8.9.
Note!
Product damage due to wrong cleaning
> Do NOT use detergent.
> Do NOT use excessive force
> Do NOT distort the O-rings.
> DO NOT use screw drivers to dismantle and assemble the water filter.