GENIUS TOY TAIWAN CO. LTD 7447-W85-B User Manual

push

pull

push

pull

switch

buon

channel

switch

socket

ON

OFF

Here are a few tips for assembling 

and using the models. Read them 

carefully before starting.

Place a tire over each of the four 

wheels before you build the first 

model.

Open the baery compartment by 

pushing on the tab on the back of 

the RF receiver unit and lifting the 

back panel up. Insert two AA 

baeries, paying aention to the 

polarity indicated in the 

compartment and on the 

baeries. Close the compartment 

again.

Open the baery compartment by 

pushing on the tab on the boom 

of the RF baery box. Insert six 

AA baeries, paying aention to 

the polarity indicated in the 

compartment and on the 

baeries. Close the compartment 

again.

To control a model, turn on both 

the motor unit and the remote 

control unit by moving their 

switches from the “off” position 

(O) to the “on” position (–). The 

lights will flash on the RF remote 

control unit and receiver while 

they establish a connection. Once 

a connection is established the 

lights on the receiver will turn off 

and the light on the remote 

control unit will be solid. If you 

are using multiple RF remote 

control units and baery boxes in 

the same area, set the remote 

control units to different channels 

and then establish connections to 

the baery.

The left side of the RC unit 

controls the socket on the left 

side of the baery box. The right 

side of the RC unit controls the 

socket on the right side of the 

baery box.

If you want your model to 

move in the opposite direction 

when you press one of the RC unit 

buons, you can simply rotate 

the direction of the plug in the 

socket 180 degrees.

SWITCH

POWER

rounded

flat

Take a careful look at the different assembly 
components. Red anchor pins, blue anchor pins, 
joint pins, and shaft plugs all look prey similar 
at first glance. When you assemble the models, it’s 
important to use the right ones. The blue anchor pins 
are shorter than the red ones.

Use the anchor pins to connect 
frames and rods.

The building system contains 
axles (also called shafts) of 
various lengths. When assembling 
the model, always be sure that 
you’re using the right one.

When you want to take your model apart 

again, you will need the anchor pin lever. 

Use the narrow end of the lever 

to remove the 
anchor pins. You 
can use the wide 
end to pry out 
shaft plugs.

If pulleys or gears are mounted too tightly against 
other components, they can be hard to turn. If you 
leave a gap of about 1 mm between the gear or 
pulley and an adjacent component, it will turn easily. 
In some of the models, a washer is used to ensure this 
kind of spacing. (There are no gears included in this 
kit.)

A

B

C

D