NEOSEN ENERGY EZI User Manual
warming drawers, wine refrigerators, etc. Verify cabinet/support measurements
before cutting the top. There should be a support strip between the transmitter
and any cutouts or the edge of the top.
before cutting the top. There should be a support strip between the transmitter
and any cutouts or the edge of the top.
The transmitter does generate some heat and ideally is installed such that it
shares airspace with the cabinet interior.
shares airspace with the cabinet interior.
If placing above a drawer, make sure there is sufficient clearance, including
drawer contents.
drawer contents.
Install so that the transmitter will be accessible by the customer. If there is a
warranty replacement the customer will need to be able to remove and replace
the transmitter. Make sure the power and micro USB ports will be accessible
after installation. Plan for power cable routing and mounting of the transformer.
The power supply has a 1.2 m (47") DC cable, 111 mm x 51 mm x 36 mm (4.4"
x 2.0" x 1.4") transformer and 1.2 m (47") AC cable. A four-unit power supply
is available separately.
warranty replacement the customer will need to be able to remove and replace
the transmitter. Make sure the power and micro USB ports will be accessible
after installation. Plan for power cable routing and mounting of the transformer.
The power supply has a 1.2 m (47") DC cable, 111 mm x 51 mm x 36 mm (4.4"
x 2.0" x 1.4") transformer and 1.2 m (47") AC cable. A four-unit power supply
is available separately.
If more than one transmitter is installed they should be at least 150 mm (6")
from each other.
from each other.