NEOSEN ENERGY NEO-0002 User Manual
All rights reserved by Neosen Energy LLC, 2016
Step 3/7
With the no.8 screws attached, place the charger on top of the mounting plate so that
the screws are aligned with the sockets on the mounting plate.
the screws are aligned with the sockets on the mounting plate.
Step 4/7
Connect the provided power supply to the socket at the terminal point circled below.
Step 5/7
From the underside of the substrate, place the charger with the attached mounting
plate into the recessed hole. If the mounting plate is not flush against the underside, use
a Philips head screwdriver to loosen the no.8 screws until flush. Note that the
transmitter MUST sit flush against the underside to operate properly.
plate into the recessed hole. If the mounting plate is not flush against the underside, use
a Philips head screwdriver to loosen the no.8 screws until flush. Note that the
transmitter MUST sit flush against the underside to operate properly.