Marmitek Control Anywhere 09665 User Manual

1.  The remote must be in TV Mode with the "second" display screen being shown.

2.  Press and hold the Touchscreen "SLEEP" Key until the LED remains on (this occurs

after approximately 2-3 seconds) and display shows the Sleep Setup Screen.

3.  Release the "SLEEP" key.

4.  Press and release the numerical keys (01-99) for the time required. The LED will

blink off to indicate keypress acceptance and the remote display will return to
normal operation.

5.  TV Sleep Timer now set. Leave the Remote pointing towards the TV with an

unobstructed path. To cancel the Sleep Timer, press and release the Power key in TV 
Mode or press and hold the SLEEP key until the remote beeps twice.

You can program the EasyTouch 35 in three different ways.

1.  When your equipment is one of the following six brands (Philips, Sony, Thomson,

Saba, Grundig, Nokia) you can use the Brand Search method. Use method A in this
case.

2.  Are you using another brand of equipment ? If so, find your brand in the code book,

and use method B to program your EasyTouch35.

3.  If the above two methods are not working, you can use method C: search for the

codes manually.

4.  If none of the above methods work with your equipment, you can add the codes

yourself by learning the codes of your original remote. This is explained in chapter 11.

You program the ET35 using the Setup key and following the procedures below. Each
keypress is acknowledged with an LED blink and a beep from the remote. 3 LED blinks
and a beep indicate an incorrect or invalid entry.

Method A: Programming using the Brand Search method
It is possible to search for your appliance’s code by entering the brand of the appliance
you wish to control.

1.  Make sure your appliance is switched on. If not switch it on manually

2.  Activate your ET35 remote by touching the screen

3.  Press and hold Setup key until the LED remains on (this occurs after approximately 2-3

seconds) and display shows Main Setup Screen.

4.  Release Setup key.

5.  Press and release the Touchscreen "CODE" Key.

6.  Display shows the Mode Setup Screen. Press and release desired Mode key (TV, VCR,

20055_20061108_UG_EasyTouch_35_touchscreen_remote  09-11-2006  10:22  Pagina 9