Cisco T3 kit CAB-T3-KIT5= User Manual
Product codes
CAB-T3-KIT5=
Page 9 of 28
78-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
Leveling the systems
1.
In order to level the systems, use 4 pcs of the M10×30
screw in the holes marked in the picture below for
each bottom module. Loosen nuts before adjusting
the pin bolts down. When proper adjustment has been
done, tighten nuts again. You may want to open the lid
completely when doing this—observe the tip on page
15.
screw in the holes marked in the picture below for
each bottom module. Loosen nuts before adjusting
the pin bolts down. When proper adjustment has been
done, tighten nuts again. You may want to open the lid
completely when doing this—observe the tip on page
15.
2.
Unpack the 2 angle plates and the 8 nut plate for angle
plates from the box marked “T3 Floor structure and
columns”. Fasten with M4 × 14 screws through the holes
on top side on the monitors and with M4 ×40 screws
and washers through the holes of the bottom modules.
Use the short screw at the monitor top and the long
screw at the bottom module top. Use the shims plates
inside the angle plate. Note that the top cover and the
door must be opened in order to do so.
plates from the box marked “T3 Floor structure and
columns”. Fasten with M4 × 14 screws through the holes
on top side on the monitors and with M4 ×40 screws
and washers through the holes of the bottom modules.
Use the short screw at the monitor top and the long
screw at the bottom module top. Use the shims plates
inside the angle plate. Note that the top cover and the
door must be opened in order to do so.
Bottom
module
module
Table columns installation
1.
Remove the door of the table column while the column
is still in the box. Then take the column out of the
box. Remove the cover as shown below. The column
covers and the doors shall not be mounted yet, so we
recommend that you put them in a place where they
will not become subject to damage.
is still in the box. Then take the column out of the
box. Remove the cover as shown below. The column
covers and the doors shall not be mounted yet, so we
recommend that you put them in a place where they
will not become subject to damage.
The columns are not identical, place the one marked
left to the left and the one marked right to the right. See
the following page for a definition of left and right.
the following page for a definition of left and right.
2.
Mount the columns using 12 × nut M8 (Captive washer
nut) for each column (24 altogether).
nut) for each column (24 altogether).
Keys for the door locks can be found in the protective foam
in the table column box.
in the table column box.