Cisco T3 kit CAB-T3-KIT5= User Manual
Product codes
CAB-T3-KIT5=
Page 7 of 28
78-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
5.
Unpack the first system and take out the bottom
module. Unscrew the top screw on the
module. Unscrew the top screw on the
left
side in
addition to the cable hatch cover.
6.
Attach the module to the floor structure—making it
become the right bottom module—by means of 4 nuts
type M8, as shown.
become the right bottom module—by means of 4 nuts
type M8, as shown.
7.
Insert the right DNAM cable 117856 and attach it
to the right DNAM module, as shown, This must be
done
to the right DNAM module, as shown, This must be
done
before
the monitor is mounted onto the bottom
module. Once the monitor is mounted, cable insertion
will become very difficult.
will become very difficult.
The DNAM cable 117856 is located in the accessories
kit.
kit.
8.
Unpack the monitor assembly and lift it onto the bottom
module. It requires a minimum of four persons to lift the
assembly, using the attached straps and gloves. Local
codes may require more persons.
module. It requires a minimum of four persons to lift the
assembly, using the attached straps and gloves. Local
codes may require more persons.
Caution!
Make sure you hold the monitor level, otherwise
one of the straps may slip.
Caution!
Make sure the grilles have not been mounted when you do this!
9.
Remove the screw on the monitor, as shown.