Allied Telesis 2-Slot Redundant PSU Chassi f/ AT-9700 Series AT-RPS9700 Leaflet

Via Motta 24 

6830 Chiasso 

Switzerland 

 

Visit our website at www.alliedtelesyn.com 

 
The AT-RPS9700 can supply redundant power for up to two 
AT-9700 Series Ethernet switches. It provides external power 
to the switch should the primary (internal) power supply unit 
fail. Initially, it contains no power module, but can house up to 
two AT-PWR9700 power modules. Each AT-PWR9700 power 
module can support one switch. You can purchase additional 
power modules from your Allied Telesyn supplier. 

 
The Allied Telesyn web site at www.alliedtelesyn.com offers 
you an easy way to access the most recent documentation, 
software, and technical information for all of our products. For 
details on the features and functions of your Allied Telesyn 
AT-9700 Series Gigabit Ethernet Switch, refer to the following 
manuals from our web site: 

 

❑ AT-9724TS Series Gigabit Ethernet Switch Installation  

Guide 
PN D617/10032 

 

 
Make sure the following items are included in the shipping 
package. If any item is missing or damaged, contact your 
Allied Telesyn sales supplier for assistance. 
 
❑ AT-RPS9700 Power Supply Chassis  
❑ Installation Guide 
❑ Warranty Card 

 

 
If you have purchased the AT-PWR9700 power module, 
make sure the following items are included in the shipping 
package. If any item is missing or damaged, contact your 
Allied Telesyn sales supplier for assistance. 
❑ AT-PWR9700 Power Module 
❑ DC Power Cord 
❑ AC Power Cord (USA) for operation in USA/Canada 
❑ AC Power Cord (UK) for operation in United Kingdom 
❑ AC Power Cord (Europe) for operation in Europe 
❑ Installation guide 
❑ Warranty card 

 
Caution 
Before installing the AT-RPS9700 power supply, refer to 
Appendix B in the AT-9700 Series Fast Ethernet Switch 
Installation Guide for electrical safety and emission 
information. 

 

 
Note 
The redundant power supply should be installed close to the 
switches so that you can easily connect the RPS cables to 
the unit. It is recommended that you install the redundant 
power supply directly above or below your AT-9700 
Series Gigabit Ethernet switch or in a directly adjacent rack. 
 
 
Perform the following procedure to install the power supply 
chassis  in a standard 19-inch rack. 

 

 

 
 
1. Mount the AT-RPW9700 Power Supply Chassis  in the 19-
inch rack using standard screws (not provided). 
 
2. Insert an AT-PWR9700 Power Module into one of the 
empty slots in the AT-RPS9700 chassis. 
 

 

 
3. Tighten the screws holding the AT-PWR9700 Power 
Module in place. 
 
4. Attach the provided DC power cord to the DC connector on 
the back panel of the AT-RPS9700 power supply. 
 
5. Connect the other end of the DC power cord to the RPS 
Input connector on the back panel of the switch.