Liebert MPXIPC-NXH30XXX User Manual

During normal operation, MPX BRMs (Branch Receptacle Modules) are hot-swappable. While adding 

or removing an MPX BRM, no user loads can be connected to the MPX BRM. Attempting to do so may 

damage the Liebert

®

 MPX

™

 or connected equipment.

To attach either the MPX PEM

™

 or a MPX BRM:

1. Orient the module so that the power conducting tabs fit into the power bus on the MPX PRC

™

 and 

the communication contacts will fit into the MPX PRC’s communication bus (see Figure 13).

2. Make sure that the integral connectors at each end of the module are oriented so they will fit into 

the slot on the MPX PRC (Power Rail Chassis).

3. Press the module firmly onto the MPX PRC.
4. Secure the module to the Power Rail Chassis with the Integral Connectors; there is one on each 

end.
a. Use a screwdriver to press each connector down. The Integral Connectors on the MPX PEM 

have tamper-resistant Torx heads; Integral Connectors on the MPX BRM have PoziDriv 

heads, however, the same size Phillips head screwdriver can be used.

b. Turn the screw until it locks and tightens, about three-quarters of a turn.

5. Repeat Steps 1 through 4 for each additional module.

Risk of arc flash and electric shock. Can cause equipment damage, injury or death.
Do not remove the screws that affix the end cap. Removing the end cap will expose energized 

parts with hazardous voltage.