Tyan S1572 ATX User Manual
23
S1572-001-01 http://www.tyan.com
None
No floppy drive installed
360K, 5.25 in.
5-1/4 inch PC-type standard drive; 360 kilobyte capacity
1.2M,5.25 in.
5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
720K, 3.5 in.
3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in.
3-1/2 inch double-sided drive; 1.44 megabyte capacity
2.88M, 3.5 in.
3-1/2 inch double-sided drive; 2.88 megabyte capacity
If a hard disk has not been installed or you have a CD-ROM/Tape drive
connected to an IDE channel, select NONE and press <Enter>.
connected to an IDE channel, select NONE and press <Enter>.
w Drive A type/Drive B type
This category identifies the types of floppy disk drive A or B, that
have been installed in your computer.
This category identifies the types of floppy disk drive A or B, that
have been installed in your computer.
w Primary/Secondary Drive Type
This category identifies the types of hard disk drives that have been in-
stalled in the computer. There are 46 predefined types and a user definable
type.
This category identifies the types of hard disk drives that have been in-
stalled in the computer. There are 46 predefined types and a user definable
type.
Press PgUp or PgDn to select a numbered hard disk type or type a number
and press <Enter>. Note that the specifications of your drive must match
with the drive table. The hard disk will not work properly if you enter
improper information for this category. If your hard disk type is not listed,
you can Type User to define your own drive manually.
and press <Enter>. Note that the specifications of your drive must match
with the drive table. The hard disk will not work properly if you enter
improper information for this category. If your hard disk type is not listed,
you can Type User to define your own drive manually.
If you select Type User, you will be asked to enter the following info. Enter
the paramters directly from the keyboard and press <Enter>. The hard disk
information should be provided in the documentation from the hard disk
vendor or the system manufacturer.
the paramters directly from the keyboard and press <Enter>. The hard disk
information should be provided in the documentation from the hard disk
vendor or the system manufacturer.
CYLS
number of cylinders
HEADS
number of heads
PRECOMP
written precom
LANDZONE
landing zone
SECTORS
number of sectors