Allied Telesis X8106 User Manual
Chapter 7: Powering On the Chassis
156
Connecting the
Grounding Wire
with Bare Wire
To attach the grounding wire to the power supply with bare wire, perform
the following procedure:
the following procedure:
1. Prepare an adequate length of solid or stranded 10 AWG grounding
wire by stripping it as shown in Figure 109.
Figure 109. Stripping the solid or Stranded Grounding Wire
2. Use an 8 mm wrench to remove the grounding post nut and washer,
shown in Figure 107 on page 154, from the grounding post on the
power supply.
power supply.
3. Wrap the grounding wire clockwise around the base of the grounding
post, as shown in Figure 110.
Figure 110. Attaching the Bare Grounding Wire to the Grounding Post