Panasonic PT-DZ680ULS User Manual
76 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
[ECO]
Set when high luminance is not required.
Note
r
f
When [ECO] is set, the power consumption and operation sound can be reduced while the lamp life can be increased.
[STANDBY MODE]
Set the power consumption during the standby.
1)
Press as to select [STANDBY MODE].
2)
Press qw to switch [STANDBY MODE].
r
f
The setting will change between [NORMAL] and [ECO] each
time you press the button.
r
r
[STANDBY MODE]
[NORMAL]
Normally use this setting.
[ECO]
Use this setting to reduce power consumption during standby.
Note
r
f
When set to [ECO], network functions and <SERIAL OUT> terminal are not available during standby. Also, some RS-232C commands are
not available. When set to [NORMAL], network functions and <SERIAL OUT> terminal are available during standby.
r
f
If set to [ECO], there may be a time lag of approximately 10 seconds between turning on the power and starting projection compared to
when the setting is [NORMAL].
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
2)
Press qw to switch [SCHEDULE].
r
f
The setting will change between [OFF] and [ON] each time you
press the button.
r
r
[SCHEDULE]
[OFF]
Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (x page 76) or “How to set a
program” (x page 76) in regard to how to set the schedule.
Note
r
f
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
r
f
The
[SCHEDULE] screen is displayed.
3)
Select and assign program to each day of
week.
r
f
Press as to select the day of week, and press qw to select a
program number.
r
f
You can set the program from No.1 to No.7. “- - -” indicates that
the program number has not been set yet.
How to set a program
You can set up to 16 commands to each program.
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
r
f
The
[SCHEDULE] screen is displayed.
3)
Press as to select [PROGRAM EDIT].
4)
Press qw to select a program number and
then press the <ENTER> button.
5)
Press as to select a command number and
press the <ENTER> button.
r
f
You can change the page using qw.
6)
Press as to select [TIME], and press the
<ENTER> button.