Zebra HW46211 User Manual

Page 4-58

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

7. Remove the new cutter PCB from the antistatic bag and position it onto the 

standoffs.

8. Refer to 

. Connect the cutter power cable to connector J2.

9. Connect the cutter data cable to connector J1.

10. Route the cutter stepper motor wires between the two right-hand standoffs and 

under the bottom of the PCB. Attach the motor wires to connector J4 on the new 
cutter PCB. Ensure the black lead is to the left.

11. Refer to 

. Secure the new cutter PCB to the standoffs with the screws 

previously removed.

12. Refer to 

. Connect the cutter optical sensor to the cutter optical 

connector J3 on the new cutter PCB.

13. Dress all the wires to ensure no wiring touches any moving parts.

14. Refer to 

 and reinstall the AC/DC power supply. Reconnect 

all removed cables to the power supply.

15. Proceed to 

Note • The cutter motor leads have a polarized connector.

J4 to Stepper

Motor

J3 to Cutter

Optical Sensor

J1 to Main

Logic Board

J2 to DC

Power Supply

Note • When the cutter PCB is changed, the lower drive arm alignment must be 
checked.