Zebra HW46211 User Manual

Page 4-128

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Wireless PCMCIA and PCMCIA Option Board Assemblies

Access the Printer

1. Refer to 

. Turn the printer Off (O) and remove the power 

cord. Disconnect the printer communications cable.

2. Refer to 

 and remove the electronics cover.

Removing the Existing PCMCIA or Wireless PCMCIA Option Board 

Assemblies

1. Refer to 

 on 

page 4-19

. 

Remove the option card (if installed) from the card 

slot located at the rear of the printer.

The Xi

IIIPlus

 has used two different means of securing the PCMCIA board to the main logic 

board (MLB).

PCMCIA Standoffs

Refer to Figure 4-89.

1. Two plastic locking standoffs: 

Remove the screw securing the PCMCIA/wireless board to a metal standoff on the printer 
chassis.
a. Remove the screw securing the PCMCIA/wireless board to a metal standoff on the 

printer chassis.

b. Disconnect the PCMCIA/wireless board from two plastic standoffs.
c. Gently pull the PCMCIA/wireless board away from the MLB to disconnect the two 

connectors, P24 and P23, on the MLB.

d. Replace the two plastic locking standoffs with two screws, spacers, and nuts. Refer to 

 on 

 and 

.

e. To install the new hardware, refer to 

.

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.

This installation must be performed by a qualified service technician.

The printer electronics are susceptible to static discharge. Before proceeding, it 
is highly recommended that the technician wear an antistatic wrist strap 
connected to the printer chassis.