IBM Flex System V7000 Expansion Enclosure 4939H29 User Manual
Product codes
4939H29
Chapter 4. IBM Flex System V7000 Storage Node Initial Configuration
173
Draft Document for Review January 29, 2013 12:52 pm
8068ch04-Initial Config.fm
entering a password, use an SSH public key. Then store the SSH public key for each SSH
client on the Flex System V7000 Storage Node.
client on the Flex System V7000 Storage Node.
You can connect to the Flex System V7000 Storage Node CLI using PuTTY (Figure 4-30).
Figure 4-30 Connect to the CLI using PuTTY
Detailed Command Line Interface setup procedure for the IBM Flex System V7000 Storage
Node is available in Appendix A, “CLI Setup and Configuration” on page 573 and can also be
found at the following address:
Node is available in Appendix A, “CLI Setup and Configuration” on page 573 and can also be
found at the following address:
4.6.1 Record system access information
It is important that anyone who has responsibility for managing the system know how to
connect to and log on to the system. Give attention to those times when the normal system
administrators are not available because of vacation or illness. Record the following
information and ensure that authorized people know how to access the system information as
shown in Table 4-1:
connect to and log on to the system. Give attention to those times when the normal system
administrators are not available because of vacation or illness. Record the following
information and ensure that authorized people know how to access the system information as
shown in Table 4-1:
Table 4-1 Record log on information
Note: After the first SSH public key is stored, you can add additional SSH public keys using
either the management GUI or the CLI.
either the management GUI or the CLI.
Item
Value
Notes
The management IP address for the GUI and CLI
The management user ID (the default is admin)
The management user ID password (the default is
admin)
admin)
The control enclosure management IP address
Control enclosure Service IP address: node canister 1
Control enclosure Service IP address: node canister 2