IBM Flex System V7000 Expansion Enclosure 4939H29 Manual De Usuario

Chapter 4. IBM Flex System V7000 Storage Node Initial Configuration 

Draft Document for Review January 29, 2013 12:52 pm

entering a password, use an SSH public key. Then store the SSH public key for each SSH 
client on the Flex System V7000 Storage Node.

You can connect to the Flex System V7000 Storage Node CLI using PuTTY (Figure 4-30).

Detailed Command Line Interface setup procedure for the IBM Flex System V7000 Storage 
Node is available in Appendix A, “CLI Setup and Configuration” on page 573 and can also be 
found at the following address:

It is important that anyone who has responsibility for managing the system know how to 
connect to and log on to the system. Give attention to those times when the normal system 
administrators are not available because of vacation or illness. Record the following 
information and ensure that authorized people know how to access the system information as 
shown in Table 4-1: 

Note: After the first SSH public key is stored, you can add additional SSH public keys using 
either the management GUI or the CLI.

The management IP address for the GUI and CLI

The management user ID (the default is admin)

The management user ID password (the default is 
admin)

The control enclosure management IP address

Control enclosure Service IP address: node canister 1

Control enclosure Service IP address: node canister 2