Intel D845GEBV2 BLKD845GERG2L-10PK User Manual
Product codes
BLKD845GERG2L-10PK
119
5 Error Messages and Beep Codes
What This Chapter Contains
5.1
BIOS Error Messages...............................................................................................119
5.2
Port 80h POST Codes ..............................................................................................121
5.3
Bus Initialization Checkpoints ...................................................................................125
5.4
Speaker ....................................................................................................................126
5.5
BIOS Beep Codes ....................................................................................................126
5.1 BIOS Error Messages
Table 76 lists the error messages and provides a brief description of each.
Table 76. BIOS Error Messages
Error Message
Explanation
GA20 Error
An error occurred with Gate A20 when switching to protected
mode during the memory test.
mode during the memory test.
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
Could not read sector from corresponding drive.
Pri Master Drive - ATAPI Incompatible
Pri Slave Drive - ATAPI Incompatible
Sec Master Drive - ATAPI Incompatible
Sec Slave Drive - ATAPI Incompatible
Pri Slave Drive - ATAPI Incompatible
Sec Master Drive - ATAPI Incompatible
Sec Slave Drive - ATAPI Incompatible
Corresponding drive in not an ATAPI device. Run Setup to make
sure device is selected correctly.
sure device is selected correctly.
A: Drive Error
No response from diskette drive.
Cache Memory Bad
An error occurred when testing L2 cache. Cache memory may be
bad.
bad.
CMOS Battery Low
The battery may be losing power. Replace the battery soon.
CMOS Display Type Wrong
The display type is different than what has been stored in CMOS.
Check Setup to make sure type is correct.
Check Setup to make sure type is correct.
CMOS Checksum Bad
The CMOS checksum is incorrect. CMOS memory may have
been corrupted. Run Setup to reset values.
been corrupted. Run Setup to reset values.
CMOS Settings Wrong
CMOS values are not the same as the last boot. These values
have either been corrupted or the battery has failed.
have either been corrupted or the battery has failed.
CMOS Date/Time Not Set
The time and/or date values stored in CMOS are invalid. Run
Setup to set correct values.
Setup to set correct values.
DMA Error
Error during read/write test of DMA controller.
FDC Failure
Error occurred trying to access diskette drive controller.
HDC Failure
Error occurred trying to access hard disk controller.
continued