Gigaset HC450 S30852-H1799-R101 User Manual
Product codes
S30852-H1799-R101
9
Installing the Gigaset HC450 door intercom system
Gigaset HC450 / en / A31008-M1799-R101-1-7619 / Starting.fm / 13.02.2007
Ve
rs
ion 4,
16
.09.
2005
Labelling nameplates
u Label the enclosed nameplates using a
waterproof pen. Insert them in the
recesses in the doorbell keys.
u Position the doorbell key cover on the
doorbell key from above and then
apply gentle pressure at the top
and bottom.
u Replacing nameplates: Insert a small
screwdriver at an angle in the narrow
notch on either side of the doorbell key
cover. Carefully lever off the cover.
Remove the nameplate.
Mounting the HC450 control unit
Requirements
The following requirements for mounting
must be fulfilled:
u The HC450 control unit contains a
u The HC450 control unit contains a
DECT radio module. This module must
be mounted within the base station's
radio range (typically around 30 m
indoors). Check the range using the
handset before fixing the control unit.
If a connection from a DECT handset to
the DECT base station is possible at the
designated location (field strength dis-
play shows at least one bar or a call of
long duration is possible with satisfac-
tory quality), you can mount the con-
trol unit here. If there is no connection
to the base station at the designated
mounting location, the range can be
extended by means of a repeater
placed between the base station
and control unit.
u Mount the HC450 control unit at a suit-
able location along the junction wire
between the bell button and bell.
It is recommended that you mount the
It is recommended that you mount the
unit near the bell transformer. This is
normally located in the fuse box. Any
adjustment required to the fuse box
must be undertaken by a qualified
electrician.
u To ensure that a suitable mounting
location is selected, familiarise yourself
with the location of the cabling before-
hand. Watch out for the cabling
between the bell button, the bell trans-
former and the bell. Lay the cables so
that nobody can walk on or trip over
them. Before finally mounting the
control unit, check the placement of
the unit with temporary cabling by per-
forming a function test (control unit
can register with the base station, sta-
ble operation possible with adequate
connection quality from the handset to
the HC450 door intercom).
u You should also refer to the mounting
instructions for the HC450 door inter-
u The control unit must not be installed
in a fuse box or metal housing.
u The control unit must not be installed
near air conditioning systems, in areas
with strong sunlight or in dusty
environments.
u The control unit must be protected
from the direct influence of water
and chemicals.
u Areas with strong magnetic fields
(transformers, electric motors, high-
voltage lines) must be avoided.
u Cables must not be connected or dis-
connected or the HC450 control unit
installed during a thunderstorm.
u Watch out for electrical, water or gas
lines in the wall if mounting the control
unit on the wall.
Mounting
Remove the terminal cap before mount-
ing. Apply firm pressure to the terminal
cap with both thumbs and slide it in the
direction of the arrow.