Bixolon SRP-275 SRP-275AG/IFL User Manual

 

 

 

 

 

Most of the functions of this printer are governed by software, but you can monitor the printer s status by 

looking at the lights on the control panel and for some procedures you will use the buttons. 

 

This indicator light is on when the power is turned on. It blinks when the printer is in the self 
test printing standby state. Always wait until this indicator light stops blinking before you 
start using the printer and before you turn it off. 

When this indicator light is on (but not blinking), it means that the printer is out of paper or 
almost out of paper or the printer covers are open. When this light blinking, there is an 
error. (See "ERROR LED blinking pattern" in Chapter 11.) If you see this light blinking, turn 
off the printer for a few seconds and then turn it back on. If the light is still blinking, call your 
supervisor or a service person. 

When this indicator light is on, it means that the paper near end. Replace the new paper 
roll. When ERROR and PAPER OUT indicator lights are on it means paper end. Install the 
paper roll.(See "Installing paper roll" in Chapter 5.) 

Use this button to feed paper or to start self test and for hexadecimal dump mode. 
(See the instructions "Self test" (8) in this chapter for self test.) 
(See the instructions "Hexadecimal dump" in Chapter 9 for hexadecimal dump mode.)