Ideal Networks Serie 33-960 Cable tester, cable tester 33-960-3MB User Manual
Product codes
33-960-3MB
Testing Fibers
46
IDEAL
Monitoring Fiber in Real Time Mode
Monitoring Fiber in Real Time Mode
You can monitor fiber at one wavelength at a time. You can also switch
from Real time mode to Manual mode at any time.
from Real time mode to Manual mode at any time.
If you intend to test at multimode wavelengths, carefully read Launch
Conditions for Multimode Measurements on page 49.
Conditions for Multimode Measurements on page 49.
To monitor fiber in Real time mode:
1. Clean the connectors properly (see Cleaning and Connecting Optical
1. Clean the connectors properly (see Cleaning and Connecting Optical
2. Connect a launch fiber between the device under test and the OTDR
port. If necessary, set the
(see Setting Analysis
3. Press Menu, select OTDR, and then press Select.
4. Use the left/right function arrows until you see Parameters and display
the pane (F1/F2 key).
If your unit is equipped with two OTDR ports, ensure that you connect
the fiber to the appropriate port (OTDR SM, OTDR MM, or
OTDR SM Live for filtered wavelength).
the fiber to the appropriate port (OTDR SM, OTDR MM, or
OTDR SM Live for filtered wavelength).
C
AUTION
Never connect a live fiber to the OTDR SM or OTDR MM port. Any
incoming signal greater than –40 dBm will affect the OTDR
acquisition. Any incoming signal greater than –20 dBm could
damage your OTDR permanently.
incoming signal greater than –40 dBm will affect the OTDR
acquisition. Any incoming signal greater than –20 dBm could
damage your OTDR permanently.