Ideal Networks Serie 33-960 Cable tester, cable tester 33-960-3 User Manual
Product codes
33-960-3
Setting Up Your OTDR
22
IDEAL
Cleaning and Connecting Optical Fibers
Cleaning and Connecting Optical Fibers
To connect the fiber-optic cable to the port:
1. Carefully align the connector and port to prevent the fiber end from
1. Carefully align the connector and port to prevent the fiber end from
touching the outside of the port or rubbing against other surfaces.
If your connector features a key, ensure that it is fully fitted into the
port’s corresponding notch.
port’s corresponding notch.
2. Push the connector in so that the fiber-optic cable is firmly in place,
thus ensuring adequate contact.
If your connector features a screwsleeve, tighten the connector
enough to firmly maintain the fiber in place. Do not overtighten, as this
will damage the fiber and the port.
enough to firmly maintain the fiber in place. Do not overtighten, as this
will damage the fiber and the port.
Note: If your fiber-optic cable is not properly aligned and/or connected, you will
notice heavy loss and reflection.
I
MPORTANT
To ensure maximum power and to avoid erroneous readings:
³
Always clean fiber ends as explained below before inserting
them into the port. IDEAL is not responsible for damage or
errors caused by bad fiber cleaning or handling.
them into the port. IDEAL is not responsible for damage or
errors caused by bad fiber cleaning or handling.
³
Ensure that your patchcord has appropriate connectors. Joining
mismatched connectors will damage the ferrules.
mismatched connectors will damage the ferrules.